English
SUKO-1

Introduction of PTFE Ram Tube Extruder

PTFE Ram tube extruder is specially designed for the production of PTFE (Teflon) or ultra high molecular (UHMWPE) tubing.

1. PTFE Tube Ram Extruder

PTFE Ram tube extruder is specially designed for the production of PTFE (Teflon) or UHMWPE tube. According to the size of the required tube, the machine design is also different, using different molds.

 

2. Working Principle of the Machine

PTFE powder is added to the feeding barrel, the powder is fixed and shaped under the pressure of the hydraulic press, then heated through the heating chamber for a certain period of time, sintering and molding, and finally the required tube comes out, the tube can be infinitely long, the user can cut according to the required length.

 

3. Models of Machine and Datasheet
Machine Model PFG150 PFG300 PFG500
Process

Vertical Ram Extruder M/c
Power KW(Electric Motor) 15kw 22kw 72kw
Size Range OD 20-150mm 150-300mm 300-500mm
THK Tolerance 0.1-0.2mm 0.1-0.2mm 0.1-0.2mm
OD Tolerance 0.1-0.5mm 0.5-2mm 3mm
Extruded Tube Length

Continue extrude with unlimited length
Output Per Hour KG 8+ 10+ 13+
Voltage/ PH/Hz 380V 50Hz 3P 380V 50Hz 3P 380V 50Hz 3P
  • Save time, one person can operate several machines.
  • Intelligent PLC touch screen and easy to use operate.
  • Small workplace required due to its compact design and electricity saving machine.
  • Super quality output and the physical properties is adjustable.
  • Precise temperature control, reaches +-1 degree.
  • Long-life, with modern technology and optimized design.
  • High Elongation, tensile strength & specific gravity.
  • Automatic Feeding system, including stainless steel barrel.

 

4. Installation Instruction
Machine Model Height of ground floor Height of machine Over Machine space Hole Diameter
PFG150 3000-6000mm 2460mm 1000mm 300mm
PFG300 3000-6000mm 2879mm 1000mm 450mm
PFG500 3000-6000mm 3100mm 1000mm 650mm

 

5. Machine Operating Procedure

  1. Check wiring, hoses and hydraulic oil.
  2. Install the required size mold.
  3. Use automatic feeding system feeding or manual feeding, start the machine manual operation.
  4. Start heating by setting heating curve through PLC panel.
  5. The extrusion tube is sintered through a heating chamber.
  6. Cut the tube to get the length you want.
  7. The machine can be suspended and closed through the PLC control panel.

 

6. Maintenance of machines and spare parts
  • Regularly check the height, cleanliness and temperature of the hydraulic oil.
  • Clean the unused mold and apply anti-rust oil on the surface for preservation.
  • The temperature sensor of the heating ring should be installed correctly.
Post time: Nov-11-2018